Hdclone 3.8 manual11/10/2022 Trying different variants of U, O and E should bring the culprit.į -> no Firewire. The USB drivers should be disabled if the system freezes at startup. All devices connected should work nonetheless, but only at USB 1.1 speed (lest the UHCI and OHCI are disabled as well). UHCI can be found on Intel and VIA mainboards, whereas OHCI is found on all other boards.Į -> no EHCI. This disables the USB 1.1 drivers used for USB mice and keyboards on most computers except for the very latest, where no USB 1.1 controllers are to be found anyway. #HDCLONE 3.8 MANUAL SERIAL#This disables the AHCI driver, which is used to access most of the Serial ATA drives (only a small percentage is accessed via the IDE driver). This disables the SCSI drivers, for the same reasons as for IDE.Ī -> no AHCI. Usually, this is not intended, but if the system freezes on startup, this might help. This disables the IDE (ATA) driver for Parallel IDE and Serial ATA in compatibility mode. If the VGA bios is defective, letting the BIOS do the initialization might not work, so this key instructs the loader to do nothing at all and the graphics driver to do the complete initialization and not rely on the BIOS. If B is pressed, this initializations are done via calls to the BIOS prior to starting Symobi and therefore no driver of Symobi can interfere here.ĭ -> does not use any help of the BIOS initialization at all. Usually, VGA is initialized by special port accesses to the graphic hardware. This might help in case the VESA bios of the graphics card is defective.ī -> forces VGA via the BIOS. V -> forces VGA, even if VESA (True Color) would be available. Now, the new system loader will show each option: Previously, you had the memorize the varying key strokes to disable certain features. Pressing 'S' on start now shows the available Safe Modes.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |